Logo Hilscher

Technologies

  • CC-Link
  •  

netX Chip carrier - CC-Link Slave

Ready-to-solder netX Design in stamp size

Product Image

 

NRP 10-CCS-Image

NRP 10-CCS (TRAY)

Active

At a glance

  • Complete Slave interface with smallest footprint
  • Significant space savings due to integrated transformers
  • Host connection via Dual-Port Memory or SPI
  • One circuit board design for all Fieldbusses

Weitere Informationen

Description

netX Chip-Carrier for integrated communication

The network technology in automation devices from medium to high volumes is typically integrated with a chip solution, such as the flexible multiprotocol chip netX. The complete development of the communication interface is thereby carried out by the customer from scratch. Low costs per unit are opposed to development risk, increased development time and necessary in-house knowledge.

The rapid and secure alternative to in-house development is netRAPID.

netX Chip-Carrier is a solution that offers adequate costs per unit as well as reduced risk and fast time-to-market. netRAPID is a complete netX-based communication interface and contains all necessary operating components. The 32 x 32 mm compact netX carrier will be soldered to the baseboard - by hand or SMD production process. You only need to add network interface, LEDs and address switches. A simple 2-layer baseboard is sufficient.

Full functionality of netRAPID is enabled via licensed firmware, which needs to be acquired once and loaded during manufacturing process.

Technical Details

ProductProduct nameNRP 10
Part number7650.740
Brief descriptionChip carrier with CC-Link Slave interface
Network controllernetXnetX 10
Integrated MemoryRAM4 MB serial Flash EPROM
Power supply and currentSupply voltage+3,3 V DC ± 5 %
Maximum current (typically)360 mA/710 mA (at 3,3 V)
Power consumption (typical)1.2 W
Host interfaceTypeParallel dual-port memory or serial dual-port memory (SPI, mode 3)
Connector76-pin solder contacts 1 mm with 1.5 mm grid
Dual-port memory size16 KB (14 address lines), where 8 KB used by firmware (13 address lines, lowest 8 KB)
Width for the data access to the dual-port memory (DPM)8 or 16 bit
Baud rate (serial dual-port memory)Max. 50 MHz
Communication interfaceCommunication standardCC-Link Slave
Interface typeRS-485, optically isolated
Diagnostic interfaceTypeUSB or UART
ConnectorUSB or UART: Signals at Chip Carrier, available only if integrated in host system
DisplayLED displaysSYS System status
L RUN/L ERR Communication status
Permitted ambient conditionsAmbient temperature range for operation0 … +70 °C (at an airflow of 0.5 m/s)
DeviceDimensions (L x W x H)32 mm x 32 mm x 4 mm
Weightapprox. 4 g

Ordering information

Product name Part number Brief description
NRP 10-CCS (TRAY)7652.740netX Chip carrier - CC-Link Slave

Accessories

Product name Part number Brief description
NRPEB 10-CCS7600.740netRAPID Evaluation Board - CC-Link SlaveShow product
NRPLFW-CCS7601.740netRAPID Loadable Firmware - CC-Link SlaveShow product
NXPCA-PCI7902.100netX PCI adapter board

netRAPID is the rapid and secure alternative to developing your own slave using a communication controller. Since the netX chip carrier is the size of a stamp, it is integrated into the customer hardware in the same manner as a QFP part. It is designed for automated SMD series production as well as for rapid prototyping.