主页产品嵌入式模块

IP40 可互换模块

可交换模块 SPI - PROFIBUS DP 从站

可随时安装在输送链中

通用PROFIBUS DP-从站接口封装在 IP40 外壳内
通过双端口内存或 SPI 连接主机
无需工具即可进行简单的插件安装
安装和连接到载板时不需要额外的组件
NJ 10D-DPS 的功能兼容替代品

PCI Express 可交换模块

通用可交换模块 netJACK 及其 PCI Express 接口主要面向使用高性能 CPU（如 Intel Atom^®）的嵌入式市场。此外，我们还提供设有传统双端口内存以及快速串行 SPI 接口的版本。

所有类型的模块都采用密闭型 IP 40 模块的紧凑设计，安装无需使用工具。该可交换模块不会产生额外费用，因为连接器和安装导轨都设计为主系统上的接触面积或贴合。

netJACK 可以在发运前或随后由最终用户快速并轻松地进行安装。

客户可以通过 netJACK 实现全方位的通讯解决方案，例如针对驱动器，人机界面系统或识别系统。客户开发的附加功能，例如软 PLC、可视化或应用，也可实现。赫优讯针对客户的特定需求，提供成本优化的设计和生产服务。

由于使用了赫优讯网络控制器 netX，我公司提供 10 年交货保证。

NJ 52D-DPS	Parameter	Value
Product	Part number	1672.420
Product	Brief description	Exchangeable module SPI - PROFIBUS DP Slave
Communication controller	netX	netX 52
Integrated Memory	RAM	8 MB SDRAM
Integrated Memory	FLASH	4 MB serial Flash EPROM
Power supply and current	Supply voltage	+3.3 V ± 5 % DC
	Typical/maximum current	375 mA / 450 mA
	Typical power consumption	1.32 W
System interface	Bus type	Parallel or serial Dual-Port Memory
	Connector type	60 pin connector (SAMTEC FSI-130-03-G-D-AB)
	Pin distance/pin width	0.45 mm / 0.55 mm
	Dual-port-memory size	64 KByte (16 address lines), where 8 KByte used by firmware (13 address lines, lowest 8 KByte)
	Width for the data access to the Dual-Port Memory (DPM)	8/16 bit
	Serial dual-port memory interface	SPI Slave, mode 3
	Baud rate	Max. 50 MHz
Communication interface	Communication standard (protocol)	PROFIBUS DP Slave
	Interface type	RS-485, potential-free
	Connector	D-Sub socket, 9-pin
Diagnostic interface	Type	USB or UART
Diagnostic interface	Connector	Signal at host interface. Available only if integrated in host system
Display	Display	SYS System Status, green: RUN, yellow: RDY
Display	Display	COM Communication status, green: STA, red: ERR
Environment	Ambient temperature range for operation	-25 °C … +70 °C
	Ambient temperature range for storage	-40 °C … +85 °C
	Altitude	0 m … 2000 m
Device	Dimensions (L x W x H)	Length: 68.2 mm / 60 mm (with / without DSUB socket), Width: 53.4 mm (at front panel) / 50.4 mm (body), Height : 25.2 mm (at front panel) / 19.2 mm (body)
	Weight	approx. 64 g
	Housing	Closed module
	Protection class	IP40
	Mounting/Installation	Via milled footprint holes in the carrier board and retaining brackets. No mounting accessories required.
	Mounting/pulling cycles	max. 10
Configuration	Configuration software	SYCON.net
Conformity	RoHS	yes
Conformity	Reach	yes
UL certification	UL type	cURus
UL certification	UL file	E334100
Conformance with EMC directives	CE sign	yes
	UKCA sign	yes
	Emission	EN 55011 / BS EN 55011
	Immunity	EN 61131-2 / BS EN 61131-2
Tests	Shock	EN60068-2-27 Ea
Tests	Vibration	EN60068-2-6 Fc